OS-1X Ozone Switch™
Acts like a thermostat to control ozone generators and alarms
based on an adjustable ozone concentration set-point. Simple and
inexpensive.
Features:
Contractor-friendly installation.
Operates from easily available 12-24 VDC or from AC adapters
available world-wide.
Dead band to avoid system chatter.
Set-point adjustable by the installer but not by the room
occupants.
Can be installed directly on HVAC air ducts.
Typical Applications:
Control of ozone purifiers
Ozone overload protection for industrial processing and storage,
and air treatment in public places
Leakage alarm for water treatment plants, semiconductor
manufacturing, and for bleaching, cleaning, and sterilization
processes.
Specifications:
Range and Accuracy: .03-.1 ppm of ozone. Approximately 20%
Accuracy.
Response time: Within 10s of seconds of the ozone reaching the
sensor.
Measurement Principle: Advanced design HMOS (heated metal oxide
semiconductor) sensor.
Size: 76 × 64 × 42 mm (3 × 2.5 × 1.625 in).
Weight: 5oz. (140 grams)
Power Requirements: 12-24 VDC, 300 mA. AC adapters available.
Output control: SPDT non-latching relay. Contacts rated at 5 amps,
250 VAC, or 1/8 HP inductive load.
Connections: 5 Circuit totally enclosed terminal block for relay
output and DC input. Also, 2.5 mm DC power jack for AC adapter.
Indicators: Green LED: instrument on. Red LED: set-point exceeded
and relay activated.
Case: Flame-resistant ABS.
Not recommended for outdoor use or in presence of output gases.